Solarix STP installation cable, Cat6A, wire, LSOH, reel 500m SXKD-6A-STP-LSOH

“Solarix” installation cable SXKD-6A-STP-LSOH is a high-quality four-pair 6A category cable designed for use in very demanding areas, especially for high-speed 10GBaseT protocol operation. This cable flawlessly meets the requirements of international standards ANSI/TIA/EIA 568 and ISO/IEC 11801 for 6A category and EA class cables. The cable conductors are made of high-quality AWG 23 copper wire with polyethylene insulation and tested up to 500 MHz frequency range. Individual pairs are separately shielded with aluminum foil, and the sheath type is LSOH. The cable color is gray. The SXKD-6A-STP-LSOH cable is marked with a continuous meter length of 1 m and is supplied on a high-strength wooden reel, which contains all the necessary product information, including barcodes, production batch, description, and key technical parameters (e.g., NVP in the form of a QR code). “Solarix LSOH” installation cables comply with the following standards: A) Acidity of gases released during combustion IEC 60754-2: Testing of gases released during the combustion of electrical cables. Part 2: Determination of the degree of acidity of gases released during the combustion of materials taken from electrical cables by measuring pH and conductivity EN 50267-2-2: General cable testing methods under fire conditions. Testing of gases released during the combustion of materials taken from cables. Part 2: Procedures. Determination of the degree of acidity of gases released during the combustion of cable materials by measuring pH and conductivity EN 50267-2-3: General cable testing methods under fire conditions. Testing of gases released during the combustion of cable materials. Part 3: Procedures. Determination of the degree of acidity of gases released during the combustion of cable materials by determining the weighted average pH and conductivity of composite materials (B) Smoke density IEC 61034-2: Measurement of smoke density of cables burning under specified conditions. Part 2: Testing procedure and requirements IEC 61034-2: Measurement of smoke density of cables burning under specified conditions. defined conditions - Part 2: Testing procedure and requirements (this standard replaced EN 50268-2) (C) Flame resistance / flame spread of single insulated cables IEC 60332-1-2: Testing of electrical and optical fiber cables under fire conditions - Part 1-2: Vertical flame spread test for a single insulated wire or cable - 1 kW premixed flame procedure EN 60332-1-2: Testing of electrical and optical fiber cables under fire conditions - Part 1-2: Vertical flame spread test for a single insulated wire or cable - 1 kW mixed flame procedure (replaced by this standard EN 50265-2-1 -Category: CAT6A -Supported protocols [?]: 10GBaseT -Shielding: foil around each pair -Frequency width [?]: 500 MHz -Conductor [?]: 0.565 mm AWG 23 copper wire -Insulation [?]: 1.4 mm polyethylene -Sheath [?]: LSOH -Color: gray -Cable diameter: 7.3 mm -Weight: 54 kg/km -NVP [?]: 75 % -Propagation delay [?]: 500 ns/100 m -Delay skew [?]: 20 ns/100 m -Storage temperature: from -20 °C to 60 °C -Operating temperature: from -20 °C to 60 °C -Installation temperature: from 0 °C to 50 °C