PrimaCreator Value water-washable resin for 3D printers 500ml - black

Kõik toote kohta

Black resin is intended for use in 3D printers. During curing, the product may emit an unpleasant odor of low intensity. The resin hardens under the influence of UV light with a wavelength of 395 to 405 nm. 3D prints made from PrimaCreator Value have low shrinkage and high hardness after final processing. They can be dried in a special chamber or in sunlight. The product is sold in a special 500 ml container that protects the resin from drying out.

PrimaCreator resin properties

• Resin made from the highest quality components
• Environmentally friendly printing: no chemicals are required to remove print residue, only water is needed.
• Finished prints feature smooth transitions between individual layers and uniform color with a semi-matte finish
• During the molding process, the resin may emit an unpleasant, low-intensity odor.
• Designed primarily for lower-power DLP printers that use UV light to cure resin, including the Zortrax Inkspire and Anycubic Photon.
• Resin curing time is 4 to 8 seconds per layer
• Completed models can be dried in a special chamber for 2 to 5 minutes. For final hardening, the print must be kept under sunlight for 10-20 minutes. With increased cloudiness and therefore limited access to light, this time is extended to 60 minutes.

Specification:

• Modulus of elasticity: 1,882 to 2,385 MPa
• Bending strength: 40 to 58 MPa
• Deformation temperature: 80℃
• Thermal expansion: 95 E-6
• Shrinkage value: 3.35% to 4.24%
• Linear shrinkage: 1.05% to 1.35%
• Tensile strength: 30 to 52 MPa
• Tensile modulus: 1,779 to 2,385 MPa
• Density: 1.05 to 1.25 g/cm3
• Exposure: 41 to 48 j/m
• Viscosity: from 100 to 350 MPa xs
• UV wavelength of vulcanizing resin: 395 to 405 nm